Sedecal SPL-HF 2.0, Руководство по обслуживанию

Страница: 14 / 222

Portable X-ray Units
Service Manual
SM-1076R2
4
2.2 HOW TO ENTER AND STORE DATA IN CONFIGURATION MODE
Configuration data is entered from the Control Panel when the Unit is in Service
Mode. Access and configure data as indicated below:
1. Turn the Unit ON and immediately press and hold “Reset” push-button
to enter in Service Mode. The Unit starts its power-up routine and the
software version (a.e. P01 0103) is shown on the Display of the Control
Panel.
= Vers. 1, Rev. 01.03
kVp mAs
2. When the letters “ CAL ” appear in the kVp Display, release “Reset”
push-button.
kVp
3. Then the Displays show the selected power percentage (a.e. Po = 100)
followed by the standard kVp and mAs values.
Unit power = 100%
kVp
mAs
The Unit is equipped with eight (8) Configuration groups (C01 to C08)
and their subgroups are shown on the kVp Display when they are
selected.
(Refer to Table 2-1 “Configuration Menus”).
4. To enter or exit the Configuration menu:
a. Press and hold “Collimator Light” push-button and then press and
release “kVp Increase” push-button (two beeps sound). (Con)
appears on the kVp Display while “Collimator Light” is pressed,
then release “Collimator Light” (kVp Display shows C01 and both
Focal Spot Leds blink).
1
2
Press and hold Collimator Light
Press and release kVp Increase
Release Collimator Light 3
kVp