Configuring Telco Spans
89
(
Does not apply to VoIP Spans or SS7 signaling links
) If you are
configuring more than one Span at once, the
Channel Map
tab is not
available; you can configure some of these settings on the
Global Line
Settings
tab (see "Global Line Settings Tab" on page 96 for instructions).
The
Channel Map
tab of the
Span Configuration
dialog box contains
telecom settings that must be correctly defined to enable the ETM
®
System
to monitor call traffic. Improper settings degrade or prohibit proper signal
traffic, cause false signal activity, or impair Policy execution. See "At-a-
Glance Reference Table to TDM Span Telco Settings" on page 197 for
reference on these settings.
To configure the Channel Map
1.
In the
Span Configuration
dialog box, click the
Channel Map
tab.
2.
Monitoring is enabled on all channels by default. This is indicated by
the check mark in the
Enable
column.
Clear the checkbox for each channel you do not want the ETM
System to monitor.
To clear multiple adjacent channels, click the first cell to be
cleared, hold down SHIFT, and then click the last cell to be
cleared.
Channel Map
Tab
