134
Step 3: ETM® System Configuration
c.
For each Span listed in the
Members
area, click in the
Interface
ID
field
and type or select the Interface ID to match the switch.
12.
Click
OK
.
13.
Repeat this procedure for additional NFAS Groups, if applicable.
Continue with one of the following:
If SS7 Signaling is used on this Switch, see "Defining SS7 Groups" on
page 134. Otherwise, see the next bullet.
Authorize Management Server connections using the procedures in
"Configuring Management Server Settings" on page 148.
SS7 Groups comprise SS7 Bearer Spans and the SS7 Signaling Links that
carry call messaging associated with the SS7 Bearer Spans. Each SS7
Bearer Span can be present in only one SS7 Group; however, SS7 Signaling
Links can be present in multiple Groups, because they can be shared by the
SS7 Bearer Spans. An SS7 Bearer Span can be associated with up to 16 SS7
Signaling Links.
You must configure the SS7 Signaling Links before you define SS7 Groups.
If you have not already done so, complete the procedures in ―SS7 Signaling
Link-Specific Span Settings‖ on page 115 before defining the SS7
Group(s).
To define an SS7 Group
1.
In the
Telco Configuration
subtree, right-click the Switch that
represents the PBX to which the SS7 Signaling Links and Bearer Spans
are connected, and then click
Manage SS7 Groups
. The
SS7
Groups for Switch
dialog box appears.
Defining SS7
Groups
