50
Step 2: Hardware Installation
(
Applies to ETM 2100 and 3200 Appliances only
.) The Controller Card and
Digital Trunk Interface in the ETM 2100 and 3200 Appliances work
together as a unit.
IMPORTANT
The procedures below apply only to new ETM Appliance
installations; if you are removing and replacing configured Cards on an
active system, see "Removing and Replacing Cards" on page 188.
CAUTION
Do not remove the DSP PMC from the Controller Card unless
directed to do so by SecureLogix Customer support.
To install the Digital Trunk Interface/Controller Card pairs
1.
At the back of the Appliance chassis, insert the Digital Trunk Interface
into the bottom slot. The components on the Card should face up.
IMPORTANT
A Digital Trunk Interface/Controller Card pair must be
present in the system slot (the bottom slot) of the ETM 3200 Appliance
for proper operation. The Controller Card in this slot serves as the
system controller for the unit. The system Controller Card controls
communication on the compact Peripheral Component Interconnect
(cPCI) backplane, and parks the PCI bus when the bus is idle.
2.
Flip the latches inward until you hear them lock.
3.
Insert the screws into the latches and hand tighten with a screwdriver to
secure the Digital Trunk Interface in the chassis.
4.
At the front of the chassis, insert the Controller Card into the slot that
corresponds to the Digital Trunk Interface. The components on the
Card should face up.
5.
Flip the latches inward until you hear them lock.
6.
Install the screws into the latches and hand tighten with a screwdriver
to secure the Controller Card.
7.
In the 3000-series Appliances, repeat steps 1-4 for other Digital Trunk
Interface/Controller Card pairs. Cards need not be continuously
installed from the bottom up, but a Card set MUST be present in the
lowest slot.
The ETM Appliances support front-, mid-, and rear-rack mounting, and
wall mounting, by simply moving the mounting brackets to the appropriate
location on the Appliance. Mounting brackets are provided; screws are
provided for rack mounting but not for wall mounting. When shipped, the
mounting brackets are attached in the front-mounting position.
See "Removing and Replacing Appliance Components" on page 187 for the
proper procedures for removing and installing Appliance components, if
necessary.
Install the
Digital Trunk
Interface/
Controller Card
Pairs
Mount the
Appliances
