84
Module removal and replacement
TIP:
The illustrations show controller fan module replacement as you face the enclosure front and view the top panel.
Removing a controller fan module
CAUTION:
Removing a controller fan module disrupts the enclosure’s airflow. Do not remove the fan until you have
received the replacement module. It is important that all FRU module slots are filled when the enclosure is in operation.
1.
Grasp the latch tab on the interior channel wall of the enclosure, and squeeze the tab against the wall to release the
channel fan from its locked position.
2.
With your other hand, grasp the handle located on the top of the fan, and pull upwards to remove the fan from its slot
as shown in
Figure 67 Removing a controller fan
Installing a controller fan module
Refer to
when performing this procedure, but ignore the directional arrow. You need to insert the
module into the slot rather than to remove it.
IMPORTANT:
Handle the controller fan carefully, and avoid damaging connectors.
1.
Check for damage, especially to all module connectors.
2.
Align the controller fan module for use in the fan slot that is accessible from the top panel.
3.
Insert the controller fan module into the slot, and gently press down on the module until it seats firmly in its
connector.
4.
Verify that the Controller Fan Status LED is off. Verify that the front panel LED states show no amber module faults.
5.
If replacing multiple fans, repeat
1
2
