SDLG LG936, Руководство по эксплуатации и техническому обслуживанию

Страница: 86 / 122

Operation & Maintenance Manual ── LG936 Wheel Loader
76
(6) Strickling Operation
Tilt the bucket to the bottom to let the blade touch the
ground.
For hard ground, let the working equipment control
lever at the float position; for soft ground, let the lift
arm control lever at the neutral position.
Use
Reverse
transmission to strickle the ground.
(7) Towing Operation
△
!
WARNING
Before towing, must use braker block the tire to prevent the machine
rolling.
During towing, be careful to prevent severe and fatal hurt.
z If possible, the machine towed should keep the engine running to ensure braking and turning.
z If the machine towed can not start the engine, disassemble the front and rear transmission axle. If
the machine can not turn, disassemble steering cylinder.
z The connection hole of the rear frame at inner side of rear wheel can only be used for lifting and
binding, but not for towing.
z If there is no braking system for machine towed, never use soft towing but use fixing towing or
use towing bar. Connect the towing bar to the towing pin at the back of loader.
z If there is no braking system for machine towed, no one is allowed to stay on it.
z Check the towing rope or towing pin to see whether they are strong enough to surfer the weight
of the machine towed. If machine will pass clay ground or go up slope, the towing rope or towing
pin should surfer at least 1.5 times the weight of machine.
z Try to use small towing angle of towing rope to ensure the angle between towing rope and the
machine towed is within 30 ° . The height of the towing points of the two machines should be
close.
z Connection of the towing equipment and the machine should be strong.
z The weight of the towing machine should be heavier than the loader towed, and has enough
traction power and braking power to be able to pull or brake go up and down slope.