Operation & Maintenance Manual
──
LG936 Wheel Loader
65
z
Never
start, turn or brake suddenly except emergency.
z
Idle running of the machine without Loading: the gearshift should be used from low speed to
high speed accordingly. Turn left, right or brake during steadily during running.
z
Running-in of the new machine: all speeds include forward and reverse should be adjusted.
z
It is better to load bulk materials in new machine training. Do not drive to hard. The load is better
less than 70% of the standard load, and speed is better less than 70% of the maximum speed
limit.
z
Pay attention to lubricant; add lubricant in time according to rules.
z
Pay attention to gearbox, torque converter, front and rear frame, rim and brake drum temperature,
once they are overheat, please find the reason.
z
Check the bolt, nut to make sure its fastening.
Do the following works after 10 hours new machine training:
1.
Check the fastening status of bolts and nuts of all parts. Especially the bolts of diesel engine
cylinder cover, vent-pipe bolts, front and rear frame bolts, rim bolts, transmission axle bolts
and connection bolts one time entirely.
2.
Clean the coarse and extract oil filter and fuel filter.
3.
Check the loosen status of belt of fan, electrical machine and air condition compressor
4.
Check the specific gravity of storage battery electrolyte and its reserves, fasten the connect
poles.
5.
Check the oil level of gearbox. Please see “
3.6.3 Adding Oil to Gearbox
”.
6.
Check the seal of hydraulic system and s system.
7.
Check the connection and sensitivity of levers (handles).
8.
Check the temperature and connection of circuit system, power supply of electrical machine,
gauge, light and lamps and turning signals.
9.
Open the air storage tank to drain water.
The following works should be done after training of new machine:
1.
Clean the filter net at gearbox bottom and the filter cartridge of oil suction.
2.
Clean the filter cartridge of hydraulic oil tank.
3.
Replace the mobile oil of engine Please see “
3.6.1 Fuel Supplying of Engine
”.
Содержание LG936
Страница 120: ...110 Figure5 7 Electric System Theory Using YC6108G and TD226B Engine Machinery Control...
Страница 121: ...111 Figure5 8 Electric System Theory Using Weifang TD226B Engine Pilot Control Combined Switch...
Страница 122: ...112 Figure5 9 Electric System Theory Using Dongfeng CUMMINS 6BT5 9 Engine Pilot Control Combined Switch...
