SDLG LG936, Руководство по эксплуатации и техническому обслуживанию

Страница: 74 / 122

Operation & Maintenance Manual ── LG936 Wheel Loader
64
moving up if it hits the block position and you will hear the sound like “Ka Ta”, and then release your
hand, the seat will be locked at this position. If the seat is at the upper most position, pull the seat hard
upward once and then push it down, the seat will go down to the lower most position.
z Head Pillow Height Adjustment
Pull the pillow hard upward or downward with your two hands holding it, and the height of pillow
will be adjusted
1.2.11 Safety Belt
Wear the safety belt if the safety belt is assembled during operation. Check the abrasion level and the
fastness. Replace it if possible.
Adjust the length of safety belt before using to ensure the effect and comfort. Move the lock-tongue
position to adjust the length. The locker of the safety belt is at the left back of the seat. Insert the
lock-tongue into the locker, the locker will block the lock-tongue Press the red button at the side of
locker placket to release the lock-tongue from locker. Check whether the locker can block and release
the lock-tongue normally.
1.2.12 Rearview Mirror
Rearview mirrors are at the left and right positions outside the cab and top left position inside the cab.
Before operation, rotate the rearview to adjust elevation so that you can have good rearview.
1.2.13 Key
There are 2 keys for every type.
z Key for engine starting switch.
z Key for cab left and right door.
z Key for left and right door of engine cover.
z
Key for left and right net-board of engine cover.
z
Key for fuel inlet of fuel tank(Selectable)
2 ADJUST OF NEW MACHINE
New machine must be trained first to increase load step by step so that the parts of machine can be
fully adjusted to increase life. It needs 60 hours to train the new machine, please follow the notices
below:
z Run the machine at low speed level to preheat the engine.
z Never accelerate the engine suddenly in preheating period.