SATO CT4-LX, Руководство оператора, Страница: 251 / 564

251
non-Adhesive Tag
Stops after the last sheet of media is ejected.
[Option Wait Time Command]
Set whether to apply parameters specified by option waiting time <TW> command for eject cut time in
cut & print mode and partial cutter mode.
• You can set the eject cut time in the [Printing] > [Eject Cut] menu too.
• The setting range for the parameters of the option waiting time <TW> command are
000, or 005 to 200 (in units of 100 ms), but the setting range for the eject cut time is 1
to 5 seconds (in units of 1 second), so the parameters are converted as follows:
◦ 000: No eject cut
◦ 005 to 014: 1 second
◦ 015 to 024: 2 seconds
◦ 025 to 034: 3 seconds
◦ 035 to 044: 4 seconds
◦ 045 to 200: 5 seconds
[BT Command Matrix2of5]
Set the type of barcode to register when Matrix2of5 is specified by the barcode ratio registration <BT>
command.
On this product, Matrix2of5 is registered regardless of whether this setting is enabled/disabled.
[X20 Font Compatible]
Set whether to make it possible to select proportional pitch for X20 fonts. This setting also allows you
to switch compatibility with old models when proportional pitch is selected for XU fonts.
You can select fixed pitch or proportional pitch for X20 fonts. Also, when proportional pitch is
selected for XU fonts, the character widths are the same as with old models.
Fixed pitch is used for X20 fonts. Also, when proportional pitch is selected for XU fonts, the
character widths are different from the old models.
[Partial Copy]
Set whether the sequential numbering is reflected to the copy destination and printed when sequential
number <F> command is included in the copy area of the partial copy <WD> command.
Sequential numbering is reflected to copy destination and then printed.