Ross CrossOver 16, Руководство оператора

Страница: 45 / 92

CrossOver 16 User Manual (v4.0) Advanced Operation • 4–1
Advanced Operation
This chapter describes advanced operating concepts
for your switcher. Topics and information on
modifying basic concepts to fit your requirements are
also discussed.
Transition Limit
You can stop a transition at a preset position between
the two Fader limits. With the transition limit
enabled, an automatic transition will stop when it
reaches the defined limit.
To define the transition limit point:
1. Press DISS , WIPE , or DVE .
2.
Press
NEXT
until Limit is displayed.
3.
Move the Fader to the desired position you wish
to set as a transition limit.
4.
Press the
Limit
knob.
The Progress Bar next to the Fader flashes to
indicate the defined transition limit.
Note:
• Ensure that you are not on-air when setting the
transition limit as you will be moving the Fader
handle to define the preset position.
To perform a transition with a transition limit set:
1.
Initiate a transition by pressing
AUTO
TRANS
.
When the transition reaches the defined limit, it
will stop.
2. To reverse the transition, press AUTO
TRANS .
3.
To continue the transition, press the
Limit
knob to turn off the transition limit.
4. Press AUTO TRANS to complete the
transition.
To Quickly Reset the Transition Limit
• Double-press the
Limit
knob.
Modifying Wipes
Wipes can be modified to give more distinct qualities
and personalize your transitions. The following
effects can be adjusted:
• Time, Direction
• Pattern, Horizontal Multiplication, Vertical
Multiplication
• X-Position, Y-Position, Aspect Ratio
• Border, Border Color, Border Softness
• Hue, Saturation, Luminosity
• Rotation
To modify time and direction:
1. Press WIPE to display the Wipe menu.
2.
Press
NEXT
until
Time
is displayed.
3.
Use the
Time
knob to change the duration of
the wipe.
4. Use the Dirctn knob to set the direction of
the wipe. You can choose from the following:
•
Fwd
— Wipe runs in the forward (default)
direction.
• Rev — Wipe runs in the reverse direction.
5. Press the Direction knob to alternately
enable and disable the flip-flop direction feature.
You can choose from the following:
• Enabled (FF) — The first time a wipe
transition is performed, it runs in the forward
direction. Performing a second wipe
transition runs in the reverse direction.
• Disabled — Wipes always run in the
direction specified in step 4 above.
To change other wipe modifiers:
1. Press WIPE to display the Wipe menu.
2. Press NEXT to cycle through the available
wipe modifiers.
DISS WIPE DVE
NEXT
AUTO
TRANS
AUTO
TRANS
AUTO
TRANS
WIPE
NEXT
WIPE
NEXT