Ross CrossOver 16, Руководство оператора, Страница: 4 / 92

21.
CAUTION : These service instructions are for use by qualified service personnel only. To
reduce the risk of electric shock, do not perform any servicing other than that contained in the
operating instructions unless you are qualified to do so.
22.
Service barriers within this product are intended to protect the operator and service personnel
from hazardous voltages. For continued safety, replace all barriers after servicing.
23.
Certain parts of this equipment still present a safety hazard with the power switch in the OFF
position. To avoid electrical shock, disconnect all A/C power cords from the chassis' rear
appliance connectors before servicing.
24.
This product contains safety critical parts, which, if incorrectly replaced, may present a risk of
fire or electrical shock. Components contained within the product’s power supplies and power
supply area are not intended to be customer-serviced and should be returned to the factory for
repair.
25.
To reduce the risk of fire, replacement fuses must be the same type and rating.
26.
Use only power cords specified for this product and certified for the country of use. Refer to
the Product Power Cord Requirement section that follows.
27.
The safe operation of this equipment requires that the user heed and adhere to all installation
and servicing instruction contained within the equipment’s User Manual.
EMC Notices
United States of America
FCC Part 15
This equipment has been tested and found to comply with the limits for a class A Digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Notice
— Changes or modifications to this equipment not expressly approved by Ross Video Limited
could void the user’s authority to operate this equipment.
CANADA
This Class “A” digital apparatus complies with Canadian ICES-003.
Cet appariel numerique de la classe “A” est conforme a la norme NMB-003 du Canada.
EUROPE
This equipment is in compliance with the essential requirements and other relevant provisions of CE Directive
93/68/EEC .
INTERNATIONAL
This equipment has been tested to CISPR 22:1997 along with amendments A1:2000 and A2:2002 , and found to
comply with the limits for a Class A Digital device.
Notice
— This is a Class A product. In domestic environments, this product may cause radio
interference, in which case the user may have to take adequate measures.
General Handling Guidelines
• Careful handling, using proper ESD precautions, must be observed.
• Power down the system before PCB removal.