Rohde & Schwarz Smart Instruments UP300, Руководство по эксплуатации

Страница: 90 / 355

Factory Default Settings R&S UP300/350
E-1147.2759.00 6-90 Operating Manual, 11/2007
6.1.1 Generator
Note: All level parameters of the individual generator functions as well as the
frequency at SINE can be set channel independently (Ch 1, Ch 2). These
parameters are listed in two columns in the table below the “Settings”. The
function parameters applying to both channels (Ch 1&2) are listed in one
column.
Function Parameter Settings
Channel Ch 1 Channel Ch 2
f1 = f2 Off
FREQ 1 kHz 1 kHz
AMPL 100 mV (0.1 FS) 100 mV (0.1 FS)
PHASE DIFF. 0 grd
SINE
REF. VALUE 1 mV 1 mV
PDF Rectangular
AMPL 100 mV (0.1 FS) 100 mV (0.1 FS)
NOISE
REF. VALUE 1 mV 1 mV
NUMBER OF SINE 1
SPACING 100.058 Hz
REF. VALUE 100 mV (0.1 FS) 100 mV (0.1 FS)
AM STATE Off
AM FREQ 10 Hz
MULTISINE
AM DEPTH 10 %
GEN FREQ 1 kHz
HIGH LEVEL TIME 500 ms
INTERVAL 1 s
HIGH LEVEL AMPL 100 mV (0.1 FS) 100 mV (0.1 FS)
LOW LEVEL AMPL 0 0
SINE BURST
REF. VALUE 1 mV 1 mV
UPPER FREQ 7 kHz
LOWER FREQ 60 Hz
AMPL RATIO 4 4
MOD DIST
TOTAL RMS 100 mV (0.1 FS) 100 mV (0.1 FS)