ROBBE TAK5-SA2-KFA-27-F1, Инструкция по эксплуатации

Страница: 172 / 182

E Annex
If there is still milk in the stainless steel coil, the automatic heat exchanger cleaning will be
deferred for 1 hour at most, too. If an entitled animal enters the feeding station within this
time, the automatic feeder starts to prepare at least two portions of water + milk powder.
After the animal has drunk up the liquid in the mixer jar the valve control closes the corres-
ponding suction pipe and the heat exchanger cleaning starts running. If no entitled animal is
identified within 1 hour, the milk will be pressed out of the stainless steel coil by some wa-
ter and subsequently drained off via the mixer outlet valve.
If you enter „If Milk Empty Change to MP, no“ in menu „Milk Functions“, the milk in the
stainless steel coil will not be fed to the animals. It will be pumped out via the mixer outlet
valve before the cleaning process starts running.
Functional Steps „Cleaning, HE with Suction Hoses“ (see chapter 15.3)
In this menu you can activate heat exchanger cleaning including the suction hoses and the
milk hose from the milk tank to the automatic feeder. The cleaning process takes place with
detergent if the automatic feeder is equipped with a detergent dosing pump that has been
previously selected in Setup.
Turn the program switch to position 2 = Rinsing.
Select submenu „HE with Hoses“.
Press Arrow Right to move to next screen.
Press Start/Stop. If you have not activated the detergent do-
sing pump in Setup, the cleaning process will take place wi-
thout detergent. If required, you can add some detergent
manually.
If you have activated the detergent dosing pump in Setup,
after pressing Start/Stop the display will show the following
message:
Enter the detergent amount and press ENTER to confirm the
input. The display shows:
In order to prepare the suction hoses for cleaning, proceed as follows:
:
Remove the suction hoses from the teat.
:
Remove the milk hose from the automatic feeder.
:
If the milk hose has to be cleaned too, remove it from the milk tank. Before, close the
stopcock of the milk tank.
:
Put the suction hoses on the cleaning adaptor but do not connect them to the milk supply
yet. Place the suction hoses on the ground so that the liquid can flow out smoothly.
cleaning
HE with sponge^ ➔
cleaning
HE with hoses^ ➔
HE with hoses
cleaning ?
start
clean HE
detergent 10g/L
hoses
ready ?
yes