ROBBE TAK5-SA2-KFA-27-F1, Инструкция по эксплуатации

Страница: 140 / 182

140
Cleaning
After the automatic cleaning has been completed, turn the program switch back to position 1
= Feeding Mode.
Turn the program switch back to position „Feeding Mode“ only if no detergent has been
utilized or after you have verified that the system does not contain any water with detergent.
15.4.3 Compressed Air--Cleaning
Compressed air facilitates suction hose cleaning up to the top of the teat without detergent.
In order to ensure accurate cleaning, make sure that air pressure is between 2 and 3 bar.
Please note
: Air pressure over 3 bar may damage the diaphragm inside the milk solenoid
valves.
In this menu you can activate compressed air cleaning manually at any time, provided that
the automatic feeder is equipped with a device for compressed air cleaning that has been
previously registered in Setup.
Proceed as follows:
Turn the program switch to position 2 = cleaning. The display
shows:
Press Arrow Up or Arrow Down to select submenu „Air clea-
ning“.
Press Arrow Right to go to the next screen. Enter the number
of the feeding station where compressed air cleaning should
take place. Press Start.
15.5 Cleaning Settings
Menu „Cleaning, Settings“ contains all settings needed to carry out automatic heat exchan-
ger--, mixer--, suction hose-- and compressed--air cleaning. In addition, the remaining por-
tions in the mixer jar can be drained off after a pre--set time.
15.5.1 Cleaning Settings Heat Exchanger
In Menu „Cleaning Settings, Heat Exchanger“ you can enter the frequency of automatic
heat exchanger cleaning. You can choose between 1 time or 2 times per day at selectable
times.
This menu is displayed only if the automatic feeder is equipped with a fully automatic heat
exchanger cleaning that you have previously activated in submenu „Heat Exchanger with
Automatic Cleaning, Yes“.
Turn the program switch to 2 = rinsing.
cleaning
HE with sponge^
➔
cleaning
air cleaning^ ➔
air cleaning
box:1^
start
cleaning
HE with sponge^ ➔