RKC INSTRUMENT DeviceNet COM-JH, Инструкция по эксплуатации

Страница: 111 / 116

APPENDIX
IMR01Y09-E3 105
Continued from the previous page.
ID Description Get Set Type Value
Attributes
208 ST start condition Yes Yes INT See P. 69
209 Automatic temperature rise group Yes Yes INT See P. 69
210 Automatic temperature rise learning Yes Yes INT See P. 69
211 Automatic temperature rise dead time Yes Yes INT See P. 70
212 Automatic temperature rise gradient data Yes Yes INT See P. 70
213 RUN/STOP group Yes Yes INT See P. 70
214 Setting change rate limiter unit time Yes Yes INT See P. 70
215 Soak time unit Yes Yes INT See P. 70
216 Setting limiter (high) Yes Yes INT See P. 70
217 Setting limiter (low) Yes Yes INT See P. 70
218 PV transfer function Yes Yes INT See P. 70
219 PV flashing display at input error Yes Yes WORD See P. 70
220 Unused No No UINT

221 Unused No No UINT

222 Unused No No UINT

223 Unused No No UINT

224 Unused No No INT

225 Controller state 1 Yes No WORD See P. 70
226 Controller state 2 Yes No WORD See P. 71
227 Controller state 3 Yes No WORD See P. 71
228 Unused
1
No No UINT

229 Unused
1
No No UINT

230 Unused
1
No No UINT

231 Comprehensive alarm state
2, 3
Yes No WORD See P. 71
232 Controller alarm state
2, 4
Yes No WORD See P. 72
233 Error state
2, 4
Yes No WORD See P. 72
234 RUN/STOP
2, 4
Yes Yes WORD See P. 72
235 Setting update flag
2, 3
Yes No WORD See P. 72
236 Number of polling I/O
communication controllers
2, 3, 5
Yes Yes UNIT See P. 72
237 Unused No No UINT

238 COM-JH error code
2, 3, 6
Yes No WORD See P. 72
1
If this data item is set as a measured data item (IN) or setting data item (OUT) by the “Controller
communication item setting object (0xC7: C7Hex)” which sets communication data items via polling
I/O communication, it becomes the same as that when set at “0.” In addition, any data item set hereafter
is invalidated.
2
It is validated only via Explicit message communication. If this data item is set as a measured data item
(IN) or setting data item (OUT) by the “Controller communication item setting object (0xC7: C7Hex)”
which sets communication data items via polling I/O communication, it becomes the same as that when
set at “0.” In addition, any data item set hereafter is invalidated.
3
Only object instances 1 is valid.
4
Only object instances 1 and 2 are valid.
5
Data for the set number of controllers is assigned by polling I/O communication. The number of
assigned data items is the number of data items for the set number of modules in each item of the
attributes set in “Controller communication item setting object (0xC7: C7Hex).”
6
Causes of controller communication errors
−
No controllers are connected.
−
“0” is set for all controller addresses.
−
The controller timed-out after recognition.
−
An abnormal condition exists in communication.
Continued on the next page.