Redline Communications RedMAX AN100U, Руководство по администрированию и обслуживанию

Страница: 148 / 178

C-2
Redline Management Suite Administration and Maintenance Guide
Redline Communications Inc. Confidential and Proprietary
Attempt connection to BS [BS
ID] f=[nn] kHz The subscriber unit is attempting to
connect to one of the detected sector
controllers. Information only. There is no action required.
Authorization and key
exchange complete. The subscriber unit has been
authenticated by the sector controller. Information only. There is no action required.
Authorization FSM state [nn] This is current FSM status. Information only. There is no action required.
When privacy is enabled, this is one of the many
steps that subscriber must perform to complete
the authentication process.
Bad Rf Rx Calibration Rev.2
EEPROM The RF calibration data is invalid
There is an issue with the radio. The subscriber unit must be replaced.
Contact support@redlinecommunications.com
for details on returning the device.
Add classifier [CID: nnnn, Idx:
nn] A classifier associated with service
flow ID [CID], with classifier index [Idx]
has been added. Information only. There is no action required.
Broadcast Opportunity
Corrupted Opportunities have been received for
initial ranging, but the opportunity is
not appropriate (i.e. too short) for this
subscriber unit. This is a problem with the sector controller.
Normally the sector controller will allocate
opportunities based on worst-case modulation
rate.
Broadcast Ranging
Opportunity Received This message indicates that the sector
controller has provided an opportunity
for subscriber registration. This message is part of the normal registration
process.
Broadcast Ranging
Opportunity Timeout This message indicates that the sector
controller has not provided an
opportunity for a new subscriber
registration within the last 10 seconds. This message may indicate a problem with your
sector controller. Check your sector controller for
any error messages. See Appendix B,
“AN100U/UX Event Log Messages”.
If this message appears repeatedly, contact your
sector controller’s vendor for assistance. Refer to
the RedMAX AN100U/UX Base Station User
Guide.
Classification deleted for CID
XXXX All of the classifiers have been deleted
for a service flow [CID XXXX]. Information only. There is no action required.
Classifier deleted [Idx: nn] The classifier [Index: Idx] has been
deleted. Information only. There is no action required.
Classifiers deleted for SF with
CID XXXX All classifiers have been cleared for
the service flow [CID XXXX]. Information only. There is no action required.
CLI reboot request A system reboot command has been
initiated from the command line
interface, Information only. There is no action required.
Table C-1 Subscriber Event Log Messages (continued)
Message Description Analysis