Rans S-7S COURIER, Текстовое руководство

Страница: 163 / 203

06/15/2011
09A-03
Surface clearance
17. Refer to FIGURE 05F-04.
•
The minimum clearance between aileron and wing tip is 0.13”.
•
The minimum clearance between aileron and flap is 0.2”.
Operational check
18. Move the controls in the cockpit throughout the full range of deflection.
Check for:
•
Correct deflections of control surfaces.
•
Interference of controls, linkages, cables, surfaces with other
components.
•
Excessive friction.
FLAP RIGGING
Neutral position
(AFTER WING INSTALLATION/ AFTER SETTING OF WASHOUT)
19. Place flap handle in flaps retracted position.
20. Using the modified wing washout rigging board as shown in FIGURE 09A-
09 . Hold the rigging board so that it is contacting the bottom side of the
leading edge spar and the bottom side of the trailing edge spar at
approximate flap half span. The trailing edge of the flap should rest on the
shim (level with lower surface of both spars).
21. Adjust the female rod end on the flap cable as required for neutral flap
position.
CAUTION: Minimum thread engagement is 10 full turns.