Rans S-7S COURIER, Текстовое руководство

Страница: 158 / 203

09/01/2014
08D-01
S-7S STATION 3 CLOSE OUT INSTALLATION
The Station 3 Close Out is a thermal formed plastic cover. Some trimming is
required before installation.
1. Modify Hold Down Strip per FIGURE 08D-01 . Slide Hold Strip between
welded fuselage tabs and Baggage Compartment Bottom. Locate and drill
#11 holes.
2. Hold Down Strip may be bent by clamping under a 2x4 block to edge of
table. About half of width should hang over edge of table. Use a board and
press down on overhang until proper bend is acquired. Refer back to
FIGURE 08D-01 .
3. Follow the molded in trim lines and check fit frequently. Refer to the parts
drawing for general configuration.
4. Provide sufficient clearance for the Rudder Cables and the Control Stick
Torque Tube.
5. Mark and drill four 1/4" holes at the lower mount tang and the upper mount
bracket locations. Close Out will attach with supplied screw rivets.
HINT: It
may be easier to locate lower mount holes without Baggage Compartment
in place.
6. Check that the Close Out does not interfere with any of the control system
elements.
NOTE: You may want to attach the vertical portion of the Close
Out to the fuselage, after painting, with self-adhesive Velcro. Velcro will
allow easier access for inspections than double stick tape.
Lower edge of
Close Out may also be trimmed to allow clearance for Fuel Lines, antenna
cables, and electrical lines as needed.
7. Hold Down Strip serves to hold Close Out against Baggage Compartment
Bottom and should be installed after Close Out is attached.