Rans S-7S COURIER, Текстовое руководство

Страница: 142 / 203

06/15/2011
07B-01
AILERONS AND FLAPS
1.
Use a light hammer and form AFT ends of ribs to follow contour of trailing
edge spar.
2. Clean the entire frame thoroughly with Acetone or similar.
3. Apply anti chafe tape around sharp edges of ribs (masking tape) as shown
in
FIGURE 07B-03 .
4. Perform pre-covering check using the following items.
ˆ
Nut plates for hinge points (Flap) installed.
ˆ
Anti-Chafe tape applied around sharp edges of ribs.
5. Cut fabric large enough to fit frames as shown in FIGURE 07B-05 .
6. NOTE: The fabric is glued around the Leading Edge Spar, wrapped
around the Trailing Edge Spar and than glued to the Leading Edge Spar.
7. The fabric should extend past both ends of frames about 2”.
8. Glue fabric to Leading Edge Spars, (cut out to clear ribs) let dry and iron
edges down.
9. Wrap around Trailing Edge and glue to Leading Edge. Refer to FIGURE
07B-05 .
10. Cut and glue fabric around both ends of frames (overlap fabric).
11. Let dry and final iron entire surface for tightening of fabric.
12. Apply Drain Grommets (to the bottom side), patches, and tapes (in this
order).
13. Refer to FIGURE 07B-13 for Ailerons.
14. Refer to FIGURE 07B-14 for Flaps.
15. Iron along tapes and iron down tape edges.
16. The Ailerons and Flaps are now ready for primer and paint.