Rans S-7S COURIER, Текстовое руководство

Страница: 122 / 203

09/01/2014
06A-03
15. Cut away a small portion of the protective plastic coating from the
perimeter of the windshield. Cleco the Trim Strip Spacer to the "Z" Strip.
Position the “Z” strip to the upper fuselage door frame tube on the inside
of the fuselage so that the drilled flange is flat against the windshield and
the cupped portion is capturing the tube. See
FIGURE 06-06 . Hold the
windshield and “Z” strip assembly tight against the fuselage frame. Mark
on the Windshield the forward edge of the Trim Strip Spacer. Trim
material from Windshield to mark, to allow the Trim Strip Spacer to set aft
and flush with Windshield. See
FIGURE 06-06A .
16. Cleco Windshield Trim Strip, "Z" strip and Trim Strip Spacer in position on
the door frame.
NOTE: The lower end of the trim strip will be riveted
together with the boot cowl and the front trim strip to the rear most tab on
the fuselage frame.
Transfer drill through the tab and cleco.
17. All parts should stop short of the centerline of the door frame tube to allow
for the door.
18. Modify the lower side edge of the forward trim strip for better fit as shown
in
FIGURE 06-06 . Trim the Windshield Trim Strip as needed at the top.
19. The Acrylic windshield will be mated to the Lexan skylight with upper and
lower mating strips. Refer to
FIGURE 06-06B for drilling the ends of
mating strip assembly. Cleco Mating Strip Spacer between Mating Strips
making sure the forward side is tight against the aft edge of the
windshield.
20. Mark support ribs 1/4" aft of mating strip.
21. Position FWD hold down strip with hold down strip spacer forward of
mating strip along edge of windshield. Transfer drill #30 into wing and
cleco.
CAUTION: Use a drill stop and do NOT drill into fuel tank.
22. Locate and drill the holes on top centerline of each rib as shown in
FIGURE 06-05 . Remove support ribs from fuselage frame to allow easier
drilling. Do NOT drill completely through the ribs, but only through the top
surface of the rib. After all holes are drilled, re-install the support ribs and
rivet per parts manual. Use a stainless steel rivet at the aft end of the
center rib.
23. Slide Skylight between Mating Strips making sure it is centered side to
side and is tight against Mating Strip Spacer.
24. Mark and remove the protective plastic along each skylight rib. Starting at
the forward hole, working your way aft and alternating from side to side,
drill #30 through the skylight into each hole in the ribs. Cleco as you go.
Do
NOT Drill into the Windshield!!
25. Transfer drill through the aft skylight tabs on the station 3 top cross tube
through the skylight. Lay the skylight aft trim strip under the skylight so
that the holes are in the center of the trim strip. Center the trim strip from
side to side. Transfer drill through the holes through the trim strip. Remove