Remote Control Commands
R&S
®
NRX
410
User Manual 1178.5566.02 ─ 07
Parameters:
<value>
*RST:
65535
13.15
R&S NRP2 Compatibility
This chapter describes all R&S NRP2 remote commands that are still functional but not
recommended to use if you start afresh. If you want to reuse programming from the
R&S NRP2, you can use these commands. But if you start with the R&S NRX without
inherited liabilities, only use the commands recommended for the R&S NRX.
13.15.1
CALCulate Commands
CALCulate<Measurement>:STATistics:MARKer:HORizontal:POSition[:X][:POWer]
CALCulate<Measurement>:STATistics:MARKer:VERTical:POSition[:Y]
............................... 410
CALCulate<Measurement>:TRACe:MARKer<Marker>:XPOSition
.......................................411
CALCulate<Measurement>:STATistics:MARKer:HORizontal:POSition[:X][:
POWer]
<value>
Available for R&S NRP2 compatibility. Recommended R&S NRX command:
CALCulate<Measurement>:STATistics:MARKer:X:POSition[:ABSolute]
The command is not fully R&S NRP2 compatible. If port
1 is assigned to measure-
ment
1 and so on, the command works. If port
1 is assigned to measurement
2, for
example, enable the R&S NRP2 emulation using
"NRP2"
.
Suffix:
<Measurement>
.
1 to 8
Measurement
Parameters:
<value>
CALCulate<Measurement>:STATistics:MARKer:VERTical:POSition[:Y]
<value>
Available for R&S NRP2 compatibility. Recommended R&S NRX command:
CALCulate<Measurement>:STATistics[:CDF]:MARKer:Y:POSition
CALCulate<Measurement>:STATistics:PDF:MARKer:Y:POSition
The command is not fully R&S NRP2 compatible. If port
1 is assigned to measure-
ment
1 and so on, the command works. If port
1 is assigned to measurement
2, for
example, enable the R&S NRP2 emulation using
"NRP2"
.
Suffix:
<Measurement>
.
1 to 8
Measurement
R&S NRP2 Compatibility
www.allice.de
Allice Messtechnik GmbH