Processor Technology Sol-PC, Руководство пользователя

Страница: 48 / 284

PROCESSOR TECHNOLOGY CORPORATION
Sol-PC SINGLE BOARD TERMINAL COMPUTER
TM
SECTION III
( ) Step 18. Install the following capacitors in the indicated
locations. Take care to observe the proper value and type
for each installation. Bend leads outward on solder (back)
side of board, solder and trim. (Refer to NOTE in Step 2.)
CAUTION
REFER TO FOOTNOTE AT END OF THIS STEP BEFORE
INSTALLING C31.
LOCATION VALUE TYPE
( ) C31* 100 ufd Aluminum Electrolytic
( ) C32 .1 ufd Disc
( ) C34 680 pfd Monolythic or Disc
( ) C35 .1 ufd Mylar Tubular
( ) C36 .1 ufd Disc
( ) C37 .1 ufd Disc
( ) C52 .001 ufd Mylar Tubular
( ) C53 .01 ufd Mylar Tubular
( ) C54 .001 ufd Disc
( ) C55 .001 ufd Disc
( ) C57 .1 ufd Disc
*Install C31 with “+” lead at the top.
( ) Step 19. Install Q2 (2N2907 or 2N3460) in its location below
and to the right of U88. The emitter lead (closest to tab on
can) is oriented toward the left of the board and the base is
oriented toward the bottom. Push straight down on transistor
until it is stopped by the leads. Solder and trim.
( ) Step 20. Install diodes D9 and DlO (1N4148 or 1N914) in
their locations below U88. Position D9 with its dark band
(cathode) to the left and DlO with its band to the right.
( ) Step 21. Install coaxial cable, composite video output. (See
Figure 3-4 for details on how to prepare cable.)
( ) Strip away about 1¼” of the outer insulation to expose
shield. Unbraid shield, gather and twist into a single
lead. Then strip away the inner conductor insulation,
leaving about ¼” at the shield end.
CAUTION
WHEN PREPARING AND INSTALLING SHIELD, BE
SURE BITS OF BRAID DO NOT FALL ONTO BOARD.
SUCH DEBRIS CAN CREATE HARD-TO-FIND SHORT
CIRCUITS.
( ) Insert inner conductor in mounting hole P1 (left side of
board), solder and trim.
111—18