Processor Technology Sol-PC, Руководство пользователя

Страница: 39 / 284

PROCESSOR TECHNOLOGY CORPORATION
Sol-PC SINGLE BOARD TERMINAL COMPUTERTM SECTION III
3.6.2 Personality Module Assembly
Since the personality module is required for testing the Sol-
PC in the later stages of its assembly, we suggest that you assemble
the personality module first. In so doing, your Sol-PC assembly will
proceed uninterrupted. Assembly instructions for the personality
module are provided in Section IV of this manual.
If you wish to wait to assemble the personality module until
it is needed, go on to Paragraph 3.6.3.
3.6.3
( )
Rev B
Sol-PCB Assembly and Test
Refer to Sol-PC assembly drawing X-3.
Step 1. Install DIP sockets. Install each socket in the in-
dicated location with its end notch oriented as shown on the
circuit board and assembly drawinq. Take care not to create
solder bridges between the pins and/or traces. (Refer to
footnotes at end of this step before installing U105.)
INSTALLATION TIP
Insert socket pins into mounting pads of
appropriate location. On solder (back)
side of board, bend pins at opposite cor-
ners of socket (e.g., pins 1 and 9 on a
16-pin socket) outward until they are at
a 45 angle to the board surface. This
secures the socket until it is soldered.
Repeat this procedure with each socket
until all are secured to the board. Then
solder the unbent pins on all sockets.
Now straighten the bent pins to their
original position and solder.
LOCATION
( ) U1 through 21
( ) U22 through 24
TYPE SOCKET
16 pin
14 pin
( ) U25 24 pin
( ) U26 through 37 16 pin
( ) U38 14 pin
( ) U39 None
( ) U40 through 43 16 pin
( ) U44 through 49 14 pin
( ) U51
( ) U50 16 pin
40 pin
( ) U52 16 pin
( ) U53 through 55 14 pin
( ) U56 8 pin
( ) U57 through 61 14 pin
(Continued on Page
III-9