Processor Technology Sol-PC, Руководство пользователя

Страница: 24 / 284

PROCESSOR TECHNOLOGY CORPORATION
Sol POWER SUPPLY
( )
2.7.3
( )
( )
( )
*( )
( )
( )
Rev
B
SECTION II
Step 23. Set Sol-REG to one side.
Power Supply Subchassis Assembly and Test
Step 24. Mount transformer (T1 for Sol-lo, T2 for Sol-20) on
power supply subchassis (L-shaped chassis).
Position transformer as shown in drawing on Page X-2 and attach
it to the subchassis with three 8-32 x 1/2 binder or pan head
screws, #8 lockwashers and 8-32 hex nuts.
bottom and outer side of chassis as shown.
on each screw and secure loosely with hex
former as close as possible to the edge of
tighten nuts.
Insert screws from
Place lockwasher
nuts. Slide trans-
the chassis and
NOTE
- -
Only one of the holes in the side wall is
used. Use the one that lines up with the
transformer
Step 25.
Prepare
( ) Twist the two
two inches at
mounting tab.
transformer leads.
black wires together except for the last
the commoning block lug end.
( ) Twist the two green wires together for their full length.
( ) Twist the two
length.
yellow wires together for their full
*( ) Twist the two blue wires together for their full length.
Step 26.
Connect Sol-PC power cable (4-wire cable which
connects to J10 on Sol-PC) to Sol-REG.
Tin ends of cable
and solder green lead to pad X9, white lead to pad X1, red
lead to pad X7 and white-yellow lead to pad X8.
Step 27. Connect Sol-20 DC power cable (5 wire) to Sol-REG.
Tin ends of cable and solder white lead to pad X4 (above R8),
red-white lead to pad X5 (between C5 and F W B 2 ) and yellow-
white lead to pad X6 (left of C5).
Step 28. Connect transformer leads to Sol-REG.
( ) Solder green leads to pads T1 and T2, white-yellow lead
to pad T3 and yellow leads to pads T4 and T5 on Sol-REG
circuit board.
Step 29. Prethread the three Sol-REG heat sink mounting
holes in the power supply subchassis shown in drawing on
page X-2 with #6 x 5/16 sheet metal screws. Remove screws.
II-14