Processor Technology Sol-PC, Руководство пользователя

Страница: 27 / 284

PROCESSOR TECHNOLOGY CORPORATION
Sol POWER SUPPLY SECTION II
Position ring over the two mounting holes located between
FWB3 and the Sol-REG so that the clamping screw is positioned
between the transformer and FWB3. Insert two 6-32 x 1/2 binder
or pan head screws from bottom side of chassis through the
mounting holes. Place #6 lockwasher on each screw and secure
with 6-32 hex nut. (Refer to Figure 2-4.)
( ) Step 37. Route Sol-PC power cable between C8 mounting ring
and the transformer,
mount C8 in its mounting ring, and
tiqhten clamping-screw.
(See Figure 2-4.)
( ) Step 38. Connect white wire of C8 cable to negative (-)
terminal of C8 and green wire to positive (+) terminal of
C8.
(This cable was soldered to the Sol-REG when you assem-
bled it.)
Remove terminal screws, place #1O lockwasher on
each screw, place cable lugs on screws and drive screws
tightly into appropriate terminals.
*( ) Step 39. Mount C9 in its mounting ring with its "+"
terminal slightly toward C8 and tighten clamping screw.
(See Figure 2-5.)
*( ) S t e p 40. Prepare R13 (39 ohm 2 watt) for installation on C9.
Solder a #10 lug to each lead of R13.
Bend leads of R13 to
fit the terminals of C9. (R13 should fit on C9 as shown in
Figure 2-5.)
*( ) Step 41. Connect Sol-20 DC power cable (5 wire) and R13 to
C9. Route cable between C8 and transformer.
Remove terminal screws from C9. Place lockwasher, terminal
screw, blue lead of Sol-20 DC cable and one R13 lead on one
terminal screw and drive it into the positive (+) terminal
on C9. Attach lockwasher, white cable lead and other R13
lead to negative (-) terminal on C9 in the same manner.
Tighten both capacitor terminals tightly.
CAUTION
- -
LOOSE CONNECTIONS ON C9 CAN LEAD TO ARC-
ING AND SUBSEQUENT POWER SUPPLY DAMAGE.
*( ) Step 42. Connect blue pigtail of Sol-20 DC cable to positive
(+) terminal of FWB3. (This pigtail has a spade lug at its
free end and is connected to the lug you just attached to
the positive terminal of C9.)
Connect white pigtail of
Sol-20 DC cable to negative (-) terminal of FWB3.
(This
pigtail has a spade lug at its free end and is connected to
the lug you just attached to the negative terminal of C9.)