Porsche Cayenne 2020, Руководство пользователя

Страница: 94 / 366

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Charging
92
charging process in accordance with IEC
61851-1, SAE J1772 or GB/T 18487 (modes 2
and 3)), and complies with national standards
and legislation.
– Porsche recommends using the Porsche Univer-
sal Charger (AC) together with the Charging
Dock or the basic wall mount. Refer to the sepa-
rate instructions for the Porsche charging
equipment and instructions for the vehicle
charging cable used.
– Vehicle charging cables without protection
(standardized in accordance with IEC 61851-1,
SAE J1772 or GB/T 18487 (mode 1)) are not
supported.
– The temperature of the vehicle should be be-
tween approx.–4 °F (–20 °C) and +104 °F (+40 °
C) during the charging process.
Inserting the vehicle plug into the
vehicle charge port and starting
the charging process
Fig. 41: Opening the charge port door
b b Transmission parking lock P activated.
b b Ignition switched off / operating device not in
ignition position 2 .
b b Vehicle unlocked.
b b
Vehicle charging cable connected to the power
grid.
1. Refer to the separate instructions for the Por-
sche charging equipment and instructions for
the vehicle charging cable used.
2. Open the charge port door by pressing on the
rear part of the door.
Fig. 42: Inserted vehicle plug
3. Press the release button ( arrow ) and insert the
vehicle plug A completely into the charge port.
After letting go of the release button ( arrow ) the
vehicle plug is locked and the charging process
started. The light indicator B and the light indi-
cator on the button C indicate the charge state of
the high-voltage battery and the locking status
of the vehicle plug.
>
Please see chapter "Display of the charge and
locking status on the vehicle charge port" on
page 93.
Information
– If the vehicle plug is inserted when you lock the
vehicle, the vehicle plug remains locked.
– The ignition can be switched on after charging
starts.
– If the vehicle key or operating device is turned to
ignition lock position 2 during the charging
process, the charging process is interrupted. If
the vehicle plug is not removed, charging re-
sumes after approx. 20 seconds.
– If the charging timer function is activated, the
charging timer controls when the charging proc-
ess starts and the charging process may not
start immediately after you insert and lock the
vehicle plug.
Ending the charging process and
removing the vehicle plug from
the vehicle charge port
1. Unlock the vehicle.
2. Press button C on the vehicle charge port.
The vehicle plug is unlocked. If a charging proc-
ess was started, it will be stopped.
3. Press the release button ( arrow ) on the vehicle
plug and pull the vehicle plug from the vehicle
charge port within approx. 20 seconds.
4. Disconnect the vehicle charging cable from the
power supply and store in a safe place.
5. Close the charge port door.