Porsche Cayenne 2020, Руководство пользователя

Страница: 124 / 366

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Flat Tire
122
CAUTION
In the event of contact
with the tire sealant
Irritation or allergic reactions after contact with tire
sealant.
e Avoid contact with skin, eyes and clothing.
e If tire sealant gets on your skin or into your eyes,
thoroughly rinse the affected part of your body
immediately with plenty of water.
e Change soiled clothing immediately.
e Consult a doctor immediately in the event of an
allergic reaction.
e
If tire sealant is swallowed, thoroughly rinse out
the mouth without delay and drink plenty of
water. Do not induce vomiting. Consult a doctor
immediately.
WARNING
Failure to detect pres-
sure loss in the tire
A tire pressure sensor that is soiled with tire sealant
cannot determine the tire pressure correctly.
e When the defective tire is changed, have the tire
pressure sensor replaced as well.
Fig. 64: Filling tire sealant
Preparing to fill
1. Leave the foreign object that caused the punc-
ture in the tire.
2. Remove the sealant bottle, the supplied "max. 50
mph (80 km/h)" sticker and the compressor
from the luggage compartment.
> Please see chapter "Luggage Compartment"
on page 164.
3. Affix the sticker in the driver's field of vision.
Filling tire sealant (Tire Mobility System -
TMS) and inflating the tire
> Refer to the operating instructions for the tire
sealant.
> Follow the separate operating instructions for
the compressor.
1. Pull plug B and pressure hose C out of compres-
sor A .
2. Screw pressure hose C onto the sealant bottle
flange D .
3. Position sealant bottle D in the recess of the
compressor with the flange facing downward.
4. Unscrew the valve cap from tire valve E of the
defective tire.
5. Screw filling hose of sealant bottle D onto tire
valve E .
6. Connect the compressor to a 12-volt socket in
the vehicle via plug B , switch on the ignition and
activate the compressor via switch F . Inflate the
tire to between 29 psi (2.0 bar) and 36 psi
(2.5 bar) and read off the tire pressure from
pressure gage G . Switch off the compressor. If
this tire pressure cannot be reached within 6
minutes, the tire is too severely damaged. Do not
continue driving with that tire.
7. Unscrew filling hose from tire valve E and refit
the valve cap.
Depending on equipment, a compressor is supplied
that must be connected to the emergency starting
points via terminal clamps and cannot be connected
to a 12-volt socket in the vehicle. Observe the se-
quence below:
Fig. 65: Emergency starting points