PerkinElmer Clarus SQ 8 MS Series, Руководство по оборудованию

Страница: 124 / 184

Clarus SQ 8 MS Hardware Guide
122
Returning the Ion Optics Assembly
CAUTION
ATTENTION
To prevent contamination of the mass spectrometer, always wear clean,
lint-free, powder-free nitrile
, nylon, or PVC gloves before touching,
removing or replacing parts. Never touch these parts with ungloved
(bare) fingers, as this will introduce contaminants into the system.
Pour éviter toute contamination du spectromètre de masse, porter
toujours des gants de nitrile, de nylon ou de PVC sans pelu, sans
peluches, sans poudre avant de toucher, d'enlever ou de remplacer les
pièces. Ne touchez jamais ces pièces avec des doigts non agglomérés,
car cela introduira des contaminants dans le système.
1.
Remove the aluminum foil covering the vacuum manifold.
2.
Ensure that the large O-ring around the ion optics assembly tub is properly set
into place.
3.
Hold the ion optics assembly by its handles and align the guide pins with the
holes in the vacuum manifold.
4.
Gently lower the ion optics assembly until it is seated on the vacuum manifold.
Ensure that the large o-ring remains in place and does not move out of its
groove in the tub.
5.
Reconnect all cables at the front and rear of the optics assembly.