Pego NECTOR, Руководство по эксплуатации и обслуживанию

Страница: 42 / 64

NECTOR
Page 42
OPERATION AND MAINTENANCE MANUAL
Rev. 03-21
9)
Tap the last link below to configure the connection.
10)
Configure the connection type:
- In the case of Ethernet connection; connect the cable to the NECTOR tool and set the
DHCP or set the desired IP/NETMASK/GATEWAY configuration. Upon completion, touch
the "Send Settings” key to configure the instrument. To enable DHCP, it will be necessary
to return to this page after a few moments to verify the IP received from the DHCP server.
- In the case of wi-fi connection, touch the WI-FI ON switch and configure the SSID and
password of the network to which the NECTOR is to connect. At the end of the setting
touch the "Send settings" button.
11)
At the end of the configuration when the instrument connects (via wi-fi or Ethernet) the icon
is activated (after approximately one minute).
12)
If the Cloud connection was configured (see points 6 and 7) after a few moments the icon is
activated to signal that the device is correctly sending the data to the Cloud Pego.