Pego NECTOR, Руководство по эксплуатации и обслуживанию

Страница: 11 / 64

NECTOR
Page 11
OPERATION AND MAINTENANCE MANUAL
Rev. 03-21
Fig. 4: Using the three pre-existing holes fix the
bottom of the box with three screws of
adequate length in relation to the
thickness of the wall on which to fix the
frame. Place a rubber washer (supplied)
between each fixing screw and the
bottom of the case.
Make all electrical connections according to the annexes diagrams for the
corresponding model (see the related tables in THE ANNEXES). To make
the electrical connections reliably and to maintain the degree of protection
of the box, it is advisable to use an appropriate cable press and/or pipe
press to tighten all the wiring harnesses. It is advisable to distribute the
passage of the conductors within the panel as neatly as possible, in
particular to keep the power conductors away from the signal conductors.
If necessary, use sealing straps
Fig. 5: Close the front by turning it 180° making
sure that all the cables are inside the
box, reconnect the battery (if present)
and tighten the 4 fixing screws. Connect
the supply voltage to the panel and
carefully
read/program all the set
parameters.
On all loads connected to the NECTOR electronic controller, install
overcurrent protection devices for short circuits, in order to avoid damage
to the device. Every intervention and/or maintenance operation must be
carried out by disconnecting the panel from the power supply and from all
possible inductive and power loads to which it is connected; this is to
ensure the maximum safety condition for the operator.