Panasonic Foma p705im, Инструкция по эксплуатации

Страница: 54 / 554

52
V
oi
ce/
Vi
de
oph
on
e Ca
ll
s
The other party ’ s name and icon are displayed if the party ’ s phone number and
name are stored in the Phonebook. However, the image is not displayed even if it is
stored in the Phonebook.
≥
If the same phone number is stored with multiple names in the Phonebook, the
name that comes first in the search order (see page
8 6) is displayed.
≥
The phone number instead of the name is displayed if the Phonebook entry is
stored as secret data or if Personal Data Lock is activated.
Each time you press
r
, the digit on the far right is cleared. If you press and hold
r
for at least one second, all the digits are cleared and the Stand-by display
returns.
≥
Press
N o
to move the cursor to the digit you want to clear, and then press
r
to
clear it. To clear all the digits on and to the right of the cursor, press and hold
r
for at least one second.
The reason why it could not be connected is displayed. (The displayed reason might
not be the same as the actual reason depending on the type of the other party
’ s
phone and contract for network services.)
Display during dialing
If you entered a wrong phone number
If a videophone call could not be connected
If “Voice call auto redial” is set to “ON”, and a videophone call is not connected, a
voice call is automatically made.
≥
Videophone calls cannot be connected to the phones that do not support the
videophone function, or to the phones that are out of the service area or turned off
even if they are videophones. If you have set “Voice call auto redial” to “ON” and
attempt to dial a phone that does not have the videophone function, the number
will be redialed as a voice call. However, this operation might not work if you call an
ISDN-synchronous 64K or PIAFS access point or an ISDN videophone that does
not support 3G-324M (as of December 2007), or if you dial the wrong number.
Note that you could be charged for the communication.
≥
Once the videophone call has started communications, redialing as a voice call will
not be made.
Messages Reasons
Check number, then
redial You have dialed a non-existent phone number.
Busy The other party is busy. (Depending on the receiver ’ s
phone, this message might be displayed during packet
communication as well.)
Busy with packet
transmission The packet communication is progress at the other end.
Out of service area/
power off The other party ’ s phone is out of the service area or
turned off.
Set caller ID to ON Your caller ID is not notified.
(when dialing “visualnet”, etc.)
Your call is being
forwarded During forwarding
Redial using voice call The other party activates Call Forwarding Service but the
forwarding destination phone does not support
videophone calls.
Upper limit has been
exceeded
Connection failed The upper limit for the plan with the limit function (Type
Limit, Family Wide Limit) is exceeded.
Please make your call
from the i-mode web
page You did not make a videophone call from the IP
(Information Provider) site among i-mode official sites (at
dialing to V-live).
Connection failed Redial after setting “Activate” of “Caller ID notification” to
“ON”.
・ This may appear in the case other than above.
Auto-redialing