Panasonic Foma p705im, Инструкция по эксплуатации

Страница: 535 / 554

42
The operation below explains how to set a connection
for packet communication without using the “FOMA PC
setup software”.
The packet communication uses AT commands to carry
out the settings from a personal computer. To specify
settings, communication software to enter AT command
is required.
When using DoCoMo Internet access service “mopera
U” or “mopera”, you do not need to set an access point
name (APN) (See page 43).
You can set “caller ID notified/not notified” (see
page 43) as required. (You need to set “caller ID
notified” when using “mopera U” or “mopera”.)
<Packet communication setting flow using AT commands>
Information
≥
The access point name (APN) is information to be registered in the
FOMA phone, so if you connect another FOMA phone, you need to
register the access point name (APN) again.
≥
To continue using the access point name (APN) of the personal
computer, register the same access point name (APN) for the same cid
number in the FOMA phone.
Setting Dial-up Network
Set Packet Communication
Confirm the COM port number
Start the communication software that enables the
entry of AT commands
Set an access point name (APN)
Set “caller ID notified/not notified”
Set others
Exit the communication software
■ AT commands
≥
The AT commands are used to control a modem. The FOMA phone,
which conforms to the AT commands, supports some extended
commands and unique AT commands.
≥
By entering AT commands, you can carry out detailed setting for packet
communication and FOMA phone, and confirm (display) the setting
contents.
≥
If the entered AT command is not displayed, enter “ATE1 ”.
To manually carry out the communication setting, you
need to specify a COM port number, which is assigned
to “FOMA P705i
μ ”/“PROSOLID μ ” (modem) embedded
after you install the “FOMA communication setup files”
(driver).
The confirmation method varies depending on the
operating system of your personal computer.
≥
When using DoCoMo Internet access service “mopera U” or
“mopera”, you do not need to set an access point name (APN);
therefore, you do not need to confirm the modem.
1
“ [ スタート (Start)]”
1
Open “ コントロー
ルパネル (Control panel)”.
2
From “ ハードウェアとサウンド (Hardware and
sound)” in “ コントロールパネル (Control
panel)”, open “ 電話とモデムのオプション
(Phone and modem options)”.
3
If the “
所在地情報
(Address information)”
display appears, enter “
市外局番/エリアコード
(City code/Area code)”, then click “OK”.
4
Open the “ モデム (Modem)” tab, confirm the
COM port number in the “ 接続先 (Access
point)” field of “FOMA P705i
μ
” or
“PROSOLID
μ
”, then click “OK”.
≥
The COM port number you confirmed is used to set an access
point name (APN) (see page 43).
≥
The contents on the property display and COM port number vary
depending on the personal computer you use.
≥
Windows Vista does not support “Hyper Terminal”. For Windows
Vista, set by using a software program which supports Windows
Vista. (Follow the settings of the software program you use.)
Confirm COM Port Number