SECTION 3 – MACHINE CONTROLS, INDICATORS AND OPERATION
3-32
– JLG Lift–
3.12 SWINGING
DO NOT SWING THE SUPERSTRUCTURE EXCEPT ON A SMOOTH, FIRM AND
LEVEL SURFACE, FREE OF OBSTRUCTIONS AND HOLES.
WHEN SWINGING, MAKE SURE THERE IS AMPLE ROOM FOR THE JIB
TO CLEAR SURROUNDING WALLS, PARTITIONS AND EQUIPMENT.
1.
With all control levers in neutral position, squeeze and
hold the
trigger switch
on front of the joystick.
2.
Move the joystick to the desired direction:
right
or
left
. The speed of the movement is proportionally
controlled by the distance of travel of the joystick.
3.
Return the controller to its centered (neutral) position
to stop, then release the trigger.
3.13 ALARMS
Overload Warning Light/Alarm
When the maximum rated load in the platform is exceeded,
RED light indicators at both the ground and the platform con
-
trol stations will blink and an audible alarm will sound. When
the overload indicator warning is activated, all machine func
-
tions are disabled. The platform must be safely unloaded until the
alarm stops.
Tilt Warning Light/Alarm
When the chassis is out of level (Refer to Table 5-1), the RED
light indicator at platform control station will illuminate. If the
machine is out of transport (stowed) position, and the chassis
is out of level an audible alarm will sound.
TO AVOID TIP OVER IF RED TILT WARNING LIGHT LIGHTS WHEN MACHINE IS
OUT OF TRANSPORT POSITION, LOWER THE PLATFORM TO GROUND LEVEL.
THEN REPOSITION MACHINE SO THAT CHASSIS IS LEVEL BEFORE RAISING
JIB.
To
order
go
to
Discount-Equipment.com
