SECTION 2 – USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
– JLG Lift –
2-9
3.
With the platform in the transport (stowed) position:
a.
Swing the boom over either of the rear tires and
ensure that the Drive Orientation indicator illumi
-
nates and that the Drive Orientation Override switch
must be used for the drive function to operate.
Reposition the platform in line with the chassis.
b.
Drive the machine on a grade, not to exceed the
rated gradeability, and stop to ensure the brakes
hold;
c.
Check that the tilt indicator is illuminated to ensure
proper operation.
Tilt Sensor Check
Figure 2-3. Tilt Sensor
Check the tilt indicator light/alarm to ensure proper operation.
Wedge a block (P/N: ST2741 - located in the manual storage con
-
tainer) to activate the tilt sensor and keep it tilted. The tilt sensor
is located on the chassis behind the right rear wheel. Refer to Fig
1.
From the platform console:
- Raise the mast by approximately 1m (3 ft.).
a.
Confirm an audible alarm sounds.
b.
Verify the tilt indicator (red) blinks.
c.
Check that the following functions are affected :
- Drive function disabled.
- Mast/Jib lift-up and swinging movements can be
performed only in creep mode.
To
order go
to
Discount-Equipment.com
