184
LD Cart Transporter User's Manual
14766-000 Rev H
10.9 Replacing Non-Periodic Parts
The brake lever cable should be adjusted at the lever cable clamp, shown in the prededing fig-
ure. There should be just enough slack so the actuator bar touches its hard stop.
Adjusting the Caster Brake Cables
The two caster brake cables are adjusted at the factory. They will normally not need to be adjus-
ted by the user.
If any adjustment is needed, refer to the preceding figure for the adjustment location. The brake
pins should be able to go down as far as the caster surface allows, without any slack.
After the caster cables are adjusted correctly, ensure that the actuator bar just touches its hard
stop. This will keep the actuator bar in position if you have to adjust the lever cable.
LD Platform Core
The LD Platform core is an enclosed unit, with internal fans as the only moving parts.
1. Access the payload bay. Refer to Accessing the Payload Bay on page 156.
2. Remove the inner rear cover.
3. Unlatch and open the battery compartment door, at the rear of the platform.
The battery compartment door is capable of being locked. You may need to unlock it.
4. Disconnect the battery power and data cables from the rear of the battery.
5. Disconnect all of the cables that are attached to the top portion of the LD Platform core.
Refer to Standard Platform Connections on page 89.
6. Remove the core mounting bracket from around the LD Platform core.
This is two pieces, held in place with four screws down into the chassis, with four more
going sideways into the LD Platform core itself. Retain all of these screws for installing
the new LD Platform core.
See the following figure:
Figure 10-27. Core Mounting Bracket
