Omron CX-Programmer 9, Руководство по эксплуатации

Страница: 279 / 542

PART 2: CX-Server PLC Tools
OMRON CHAPTER 3 – IO Table Component
CX-Server PLC Tools_ Page 29
Unit Setup
The Unit Setup for a selected rack IO option can be edited for CV-series and CS/CJ/CP series PLCs only. For
C-series PLCs, refer to
Chapter 8 - CX-Net Network Configuration Tool . Use the following procedure to edit the
Unit Setup.
1, 2, 3… 1. Highlight the rack/unit in the IO Table tree.
2. Click the right-mouse button and select Unit Setup .
3. Set the required unit setup options for the specified rack/unit.
Note: The availability of the Unit Setup option depends on the rack/unit selected. The SIOUs
attached to a PLC are shown in the IO Table component.
The PLC Communications Unit Setup dialog allows both the system and software switch memory areas
associated with a mounted Special Input/Output unit (SIOU) to be configured.
Software Switches
The Software Switch settings for a selected rack IO option can be edited for CV-series and CS/CJ/CP series PLCs.
For CV-series PLCs, the Software Switch settings appear in the IO Table tree as SIOU Units . For CS/CJ/CP series
PLCs, the Software Switch settings appear in the IO Table tree as part of the Main Rack information.
The dialog which is presented for software switch setup depends upon the type of the SIOU and allows the
software switch memory area associated with a mounted SIOU to be configured. Software switches provide status
information on each SIO unit on the PLC.
Note: It is also possible to edit the Inner Board software switches for the CS/CJ series PLC if
fitted by selecting
Inner Board Software Switches option from the PLC’s context menu.
The Software Switch dialog is displayed allowing the network unit system memory area to be configured and
transferred to the PLC. Software switches can be defined for the following:
♦ SYSMAC LINK . Allows set up of Data Link (on/off) and Internode Test (on/off) and setting of response
monitor time;
♦
SYSMAC NET . Allows set up of Data Link (on/off) and Internode Test; (on/off);
♦
Ethernet . Allows set up of Internode Test (on/off) and setting of response monitor time.
♦
Controller Link . Allows the polling status of the node to be set (whether it is a polling or polled unit) and
whether to clear the Controller Link unit EPROM.
Use the following procedure to edit the Software Switch Setup.
1, 2, 3… 1. Highlight the rack/unit in the IO Table tree.
2. Click the right-mouse button and select Software Switches .
3. Set the required software switch setup options for the specified rack/unit.
General
The General tab of the Software Switches dialog provides the complete software switches settings for a Basic unit,
PC unit, Mini-map unit, Host Link unit, Motion Control unit, ME-Net unit, DeviceNet Master unit and ISO Baud
unit. It also serves as partial software switches settings for other units.
1, 2, 3… 1. Access the Software Switch dialog for an appropriate rack/unit.
2. Set the required CIO and DM area address in the CIO Address field and DM Address field.
Data Link Area
The Data Link tab is used to control whether Data Link is generated automatically or by a specific Data Link table
for SYSMAC LINK, SYSMAC NET and Controller Link. This setup is only used if the Node Type is Master. The
list box at the bottom of the chapter is only used when Data Link is set to one of the automatic options (i.e. not
specific).
1, 2, 3… 1. Select Transfer from PLC from the Options menu to transfer the current system area
settings from the unit.
2. Select the required unit and click the right-mouse button. Select the Software Switches
setting.
3. Adjust the settings as required.