59
Uploading Data
Section 7-4
If the connection cannot be established at this point, the following dialog
box will be displayed. Click the
OK
Button and the axes registered in the
Position Control Unit will be displayed as Unknown Model.
6.
If the connection was established at Step 4, the connection status can be
restored (released in this case) here. To release the connection, click the
OK
Button. To leave the connection established, click the
Cancel
Button.
7.
When the Upload from NC Unit Dialog Box is closed, the upload will be
completed.
Note
Batch uploading will overwrite the parameters on the computer, which means
that the parameters being edited will also be erased.
When the MECHATROLINK communications cannot be started, only Unit
Parameters can be uploaded.
7-4-2
Uploading Unit Parameters
1,2,3...
1.
Click the
Upload
Button in the Edit Unit Parameter Window.
2.
Clicking the
OK
Button will start uploading Unit Parameters from the Posi-
tion Control Unit.
Clicking the
Cancel
Button will cancel uploading.
3.
When the Upload from NC Unit Dialog Box is closed, the upload will be
completed.
Содержание CX-MOTION-NCF - V1.8
