61
Comparing Data
Section 7-5
7.
When the Upload from NC Unit Dialog Box is closed, the upload will be
completed.
Note
When the MECHATROLINK communications cannot be started, Servo
Parameters cannot be uploaded. Start the MECHATROLINK communications
first and upload Servo Parameters.
7-5
Comparing Data
The objects of comparing varies depending on the operation method.
Batch Comparing
Compares the data on the CX-Motion-NCF with the Unit Parameters and
Servo Parameters of the Servo Drives registered in the scan list in the Posi-
tion Control Unit.
Comparing Unit
Parameters
Compares the data on the CX-Motion-NCF with the Unit Parameters in the
Position Control Unit.
Comparing Servo
Parameters
Compares the data on the CX-Motion-NCF with the Servo Parameters in the
Servo Drive.
Note
Before starting MECHATROLINK communications, make sure that the PLC is
in the PROGRAM Mode. Otherwise, the axis may start moving suddenly due
to the ladder execution.
Before disconnecting MECHATROLINK communications, make sure that the
axis is not operating. Disconnecting MECHATROLINK communications will
put the operating axis in the Servo Free state.
7-5-1
Batch Comparing
1,2,3...
1.
In the Axis Map Setting Window, select
Online - Compare
, click
in
the toolbar, or right-click the Position Control Unit and select
Compare
from the pop-up menu. The following dialog box will be displayed.
2.
Click the
OK
Button. All the parameters being edited will be discarded and
the Edit Windows will be closed.
Содержание CX-MOTION-NCF - V1.8
