![background image](http://html1.mh-extra.com/html/omron/cx-motion-ncf-v1-8/cx-motion-ncf-v1-8_operation-manual_744181099.webp)
78
Axis Monitor
Section 8-2
Axis Monitor Common Items
Selected Axis
Status
Basic Monitor
Name
Explanation
Title Bar
Shows the status of monitoring and communications between
Position Control Unit and Servo Drive.
• Stop: Monitoring stopped.
• Monitoring (Connection Released): Monitoring in progress,
however, communications between Position Control Unit and
Servo Drive have not been started. Therefore, information
about axes is not displayed.
• Monitoring (Connection Established): Entire information is
displayed.
Monitor Start/Stop
Button
Starts monitoring. If communications between Posi-
tion Control Unit and Servo Drive have not been
started, the connection will be established first.
Stops monitoring.
Close Button
Closes the monitor window.
Name
Explanation
Selected Axis
Specifies axes to be monitored. The axes registered in the
scan list of the Position Control Unit are displayed in the drop-
down list.
Name
Explanation
Status
Communications Status
Status of each signal is displayed.
SERVO ON
NC Unit Positioning Com-
pleted
No Origin Flag
Brake Output
Forward Rotation Limit Input
Reverse Rotation Limit Input
Origin Proximity Input
Encoder Phase Z Input
External Latch Signal 1 Input
External Latch Signal 2 Input
External Latch Signal 3 Input
Name
Explanation
Present Value
Present Value
Display
Present position, speed, etc. are displayed.
Monitor Setup
Button
Press this button to change displayed contents,
unit, and pulse rate.
Unit and pulse rate can be set only for the axes
registered in the Axis Map Setting Window.
Содержание CX-MOTION-NCF - V1.8
