Omron CX-MOTION-NCF - V1.8, Руководство по эксплуатации

Страница: 75 / 138

54
Downloading Data Section 7-3
7. Click the OK Button.
If the Servo Drive models do not match at this point, the following confir-
mation message will be displayed.
8. Click the OK Button to establish the connection and transfer Servo Param-
eters to the Servo Drive.
Clicking the
Cancel Button will cancel transferring, however, the parame-
ters that were transferred before the cancellation will already be trans-
ferred to the Servo Drive.
9. When the Download to NC Unit Dialog Box is closed, the download will be
completed.
Note When the MECHATROLINK communications cannot be started, only Unit
Parameters will be downloaded.
7-3-2 Downloading Unit Parameters
1,2,3... 1. Click the Download Button in the Edit Unit Parameter Window. The follow-
ing dialog box will be displayed.
To write Unit Parameters to the flash memory after downloading, select the
checkbox for writing to flash memory.
!Caution After downloading Unit Parameters to the Position Control Unit, always
backup the parameters in the flash memory. Otherwise, the parameter set-
tings before the download will be enabled when the power is turned ON next
time (i.e. the downloaded parameters will be lost and not be reflected), which
may cause the machines to operate in an unexpected way.