Omron CX-INTEGRATOR - V1.1, Руководство по эксплуатации

Страница: 69 / 338

2-1 Basic Procedures
2-1 Basic Procedures
This section describes the overall procedures used for the CX-Integrator
.
Basic procedure Page
PLCs with Only One Network
Communications Unit 2-2 Uploading Network Configurations
Online
PLCs with More Than One Network
Communications Unit 2-3
Uploading Network Configurations from Target PLCs Other than the Relay PLC 2-5
Reading Network Configurations and Parameters from Actual Networks and Saving
Them to Files Online 2-6
Designing DeviceNet and CompoWay/F Networks Offline 2-7
Reading Saved Parameters and Downloading Them Online to DeviceNet or
CompoWay/F Components 2-8
Directly Connecting the Computer Running CX-Integrator to CompoWay/F
Components without Going Through a PLC 2-9
Uploading Network Configurations Online
The PLC that is initially connected online form the CX-Integrator is called the relay
PLC. The relay PLC is connected directly, either serially or though a network. The
network configuration and component parameters of the relay PLC can be uploaded.
PLCs with Only One Network Communications Unit
If the relay PLC (which is the target PLC when the online connection is first made) has
only one Network Communications Unit (see note), it is not necessary to create and
transfer a local network table.
Note: Network Communications Units include Ethernet Units, Controller Link Units, SYSMAC
LINK Units, DeviceNet Units, and FL-net Units. Serial Communications Boards/Units are
not included.
Overall Procedure
Connect to a Communications Unit/port to
enable accessing it.
Connect online to the relay PLC.
Start the CX-Integrator.
Example: Select Component
−
Auto Online
from the menu bar to automatically connect
online using a serial connection.
Right-click the desired network in the Online
Connection Information Window and select
Connect
from the pop-up menu.
Right-click and select
Transfer [Network to
PC] .
Upload the network structure.
Network Configuration Example
Computer running CX-Integrator
The network address will be 0.
CS/CJ-series PLC
Relay PLC (= target PLC)
Direct serial or
network connection
One Network Communications Unit (Ethernet
Unit, Controller Link Unit, SYSMAC LINK
Unit, DeviceNet Unit, or FL-net Unit)
2-2