7-3
CompoWay/F Slaves Connected to a Computer
7-3-1
Reading from Slaves Connected to the Computer
6. The Compoway/F Finding node settings Dialog Box will be displayed.
If the CompoWay/F Slave node’s
node address is unknown:
Select the
All (0-99)
Option.
If the CompoWay/F Slave node’s
node address is known:
Select the
Selection
Option and set the CompoWay/F
Slave’s node address.
The CompoWay/F Slave upload starts when the
OK
Button is clicked.
7. The following dialog box will be displayed when the CompoWay/F Slave transfer is
completed.
Click the
OK
Button.
The following dialog box will be displayed if no CompoWay/F Slaves could be
found.
Click the
OK
Button.
8. The CompoWay/F Slave connected directly to the computer (CX-Integrator) is
displayed in the Network Configuration Window. The CompoWay/F network is also
added in the Workspace Window.
Example: Connecting an E5ZN Temperature Controller
Right-click the E5ZN Temperature Controller in the Network Configuration Wind
and select
Start Special Application – Start with Setting
ow
s Inherited
.
7-12
Содержание CX-INTEGRATOR - V1.1
