4. ADMINISTRATING PRINTERS IN NETWORK
67
4.2.3.1 NetWare Enable/Disable
To use this network card in the NetWare environment, NetWare must be
set to ENABLE on the printer’s operator panel.
To set the print server and the remote printer, use the utility and the server.
1
Confirm that the printer is in the idle state from the LCD panel and
the lamp.
2
Press “ON-LINE” button to set the printer to OFF-LINE, and hold
“MENU1” button for 2 seconds or longer to display “PRINT MODE”.
3
Press “MENU1” button repeatedly, to display “NETWORK”. After
“NETWROK” is displayed, press “ENTER” button.
4
“TCP/IP” is displayed. Press “MENU1” button repeatedly to move
to “NETWARE” Item.
5
When you see that the bottom column of the LCD of the
“NETWARE” is “ENABLE*” (* indicates that that value is set), press
“ON-LINE” button without doing anything and exit the menu.
If the bottom column of the LCD is “DISABLE*”, press “
t
” button or “
s
”
button, to have “ENABLE” displayed in the LCD bottom column, then press
the “ENTER” button to have “ENABLE*” displayed. Then, press “ON-
LINE” button to exit the menu. Now the NetWare is enabled. Set up the
print server and the print queue with utility, etc.
4.2.3.2 Confirming the setting
1
Print the menu after completing the setting of each item, to verify that
the setting has been made correctly. Press “ON-LINE” button to set
the printer to OFF-LINE, and hold the “
Menu
” button for 2 sec-
onds or longer. When “MENU HP PCL6*” is displayed, press ‘EN-
TER” button.
2
If the set values printed in the menu print are not correct, set the
values again.
