4. ADMINISTRATING PRINTERS IN NETWORK
65
5
When you see that the bottom column of the LCD is “DISABLE*”,
press “
t
” button or “
s
” button until “ENABLE” is displayed in the
LCD bottom column. Then press “ENTER” button to have the
“ENABLE*” displayed. Then, press “ON-LINE” button to end the
menu setting.
6
If you do not wish to receive print data from the network, set “NET-
WORK” to “DISABLE*” in the above procedure.
4.2.2
Setting TCP/IP
To use this network card in the TCP/IP protocol, TCP/IP must be set to
ENABLE on the printer’s operator panel.
4.2.2.1 TCP/IP Enable/Disable
1
Confirm that the printer is in the idle state from the LCD panel and
the lamp.
2
Press “ON-LINE” button to set the printer to OFF-LINE, and hold
the “MENU1” button for 2 seconds or longer, to have “PRINT
MODE” displayed.
3
Press the “MENU1” button repeatedly, to have the “NETWORK”
displayed, and press the “ENTER” button.
4
When you see that the bottom column of the LCD of “TCP/IP” is
“ENABLE*”, press “MENU1” button to proceed to set “IP BYTE1”.
If the bottom column of the LCD is “DISABLE*”, press “
t
” button
or “
s
” button until “ENABLE” is displayed in the LCD bottom col-
umn. Then press the “ENTER” button to have “ENABLE*” dis-
played (* indicates that that value is set.)
4.2.2.2 Setting IP Address
1
Following the procedure of the sub-section 4.2.2.1, “TCP/IP En-
able/Disable”, press “MENU1” button, to have “IP BYTE1” dis-
played.
2
Change the address by pressing “
t
” button or “
s
” button. (If you
hold the button for a several seconds, it will expedite the address
updating.) When the value to be set is displayed, press the Enter
key to finalize it.
3
Press “MENU1” button to move to “IP BYTE2” setting. Set up to
and including “IP BYTE4”, in the similar manner to the “IP BYTE1”.
