Ohmeda Ohio 2000 IWS Series, Руководство по эксплуатации и обслуживанию

Страница: 73 / 80

A-15
6600-0255-000 12/20/00
Appendix
A-15
Figure A-3
Heater to bed distance
6. Perform steps A through C to secure the (4) Toggler® anchor bolts
in the wall. See Figure A-4.
A. Hold the metal channel flat alongside the plastic straps and slide the channel
through the hole in the wall and track.
B. With one hand, hold the ring so the metal channel rests flush behind the wall.
Slide the plastic cap along straps with the other hand until the flange of the cap
is flush with the wall.
C. Place your thumb between the straps, and push from side to side, snapping off
the straps level with the flange of the cap.
3. Utilizing a level, position the hinge bracket on the wall. The bottom edge of the
heater mounting bracket on the model 3050 and 3100 must be 69 - 5, + 23 cm,
inches from the bed surface of the mattress that will be used. See Figure A-3. The
model 3150 integral bed warmer already comes with 69±5 cm bed-to-heater
spacing.
4. Use the hinge bracket as a template to mark the mounting holes on the wall.
5. Use a 19 mm diameter metal cutting hole saw to drill (4) holes through the dry wall
and through metal drywall tracks behind the wall.
WARNING:
w
When installing wall mounted units, to achieve adequate structural
strength all four holes must engage tracks. Should the hole saw miss a
track do not proceed. Consult the project engineer for further direction.
w
Enclosing the heater assembly inside a cabinet may prevent proper
ventilation and may create a fire hazard. If the heater is enclosed in a
cabinet, it must be equipped with a power cut-off device that prevents
operation while the cabinet is closed.
Bed Surface
Hinge
Bracket
69 - 5, + 23 cm
Place Bed Height
Label Here
16.5 cm
11.5 cm
Heater Assembly
CI.05.046
All dimensions
are nominal