Ohmeda Ohio 2000 IWS Series, Руководство по эксплуатации и обслуживанию

Страница: 20 / 80

2-4
6600-0255-000 12/20/00
2/Setup and Checkout Procedures
2-4
G. Wall Mount Checkout
CI.14.096
Figure 2-1
Wall mount pin insertion
1. Verify that the warmer is rigidly secured to the wall and the heater assembly is level.
Note: To access the control unit and display module for service procedures, either
hinge pin may be removed, allowing the warmer to pivot away from the wall.
2. Check that both hinge pins are in place and fully inserted with the pin heads at the
top of the hinge.
WARNING:
w
In the service position the strength of the hinge bracket is reduced. Never place a
patient in the bed when the heater is in the service position. Never leave the unit
unattended in the service position or with either pin removed.
CI.14.104
Patient
Temperature Elapsed
Time Display Control
Temperature Heater
Power %
Increase
Decrease Elapsed Time
Start/Hold
and Reset
100
75
50
25
5
°
C
°
C
Start
Hold
Patient Temperature
Alarms
Probe Failure
Patient Temp
System Failure
Heat Off
Check Patient
Power Failure
Reset
Tones
On / Off
Apgar
Preheat
Light
On / Off
Mode
Control Temperature % Power Elapsed Time
Bed Height
Servo
Manual
Bed
Controls*
Light
On/Off
Switch
Apgar
Tones
On/Off
Apgar
Indicator
Alarm
Lights*
Alarm
Silence
Mode
Switch*
Mode
Indicators*
* Note: Servo mode indicator, mode switch, and probe failure alarm are not present on the model 2001 international control
panel. Bed raise/lower are only present on elevating models.
Figure 2-2
Control Panel
2.3 Control Unit Checkout Procedure
WARNING:
w
Do not perform the Checkout Procedures (Mechanical and Control Unit)
while a patient occupies the warmer.
w
Complete the “Checkout Procedures” section of this manual before
putting the unit into operation. If the warmer fails any portion of the
checkout procedures it must be removed from use and repaired.