Ohmeda Ohio 2000 IWS Series, Руководство по эксплуатации и обслуживанию

Страница: 75 / 80

A-17
6600-0255-000 12/20/00
Appendix
A-17
10. Position the lower mounting bracket on the wall. Use the lower hinge bracket as a
template to mark the mounting holes on the wall for the lower bracket.
11. Remove the warmer from the wall by tapping out the (2) hinge pins from the upper
bracket.
12. Remove the lower hinge bracket from the warmer by removing the (2) hinge pins
(one on either side) that secure the bracket to the warmer.
13. Repeat steps 5, 6 and 7 to properly install the lower mounting bracket.
14. Mount the warmer by inserting the back of the unit into the upper hinge bracket
mounted on the wall, then securing by tapping in the (2) hinge pins. Secure the
warmer to the lower mounting bracket by tapping in the (2) hinge pins. Verify that
the heater assembly and side rails are rigidly secured to the wall and that the
heater is level and is parallel to the floor.
15. Refer to the Operation & Maintenance Manual for checkout procedures.
WARNING:
w
Perform Checkout Procedures before placing the unit in operation.
Drywall
19 mm Dia. Hole
Slit Ring Washer
Stud
Track
Toggler
®
Hinge Pin
Hinge Bracket
CI.05.045
44 cm
Figure A-5
Mounting the warmer
Heater Assembly
Power Cord
Mounting Screw
Flat Washer