Ohmeda Ohio 2000 IWS Series, Руководство по эксплуатации и обслуживанию

Страница: 47 / 80

4-1
6600-0255-000 12/20/00
4/Cleaning and Disinfecting
4-1
4/Cleaning and Disinfecting
In this section
4.1 Cleaning .............................................................................................................. 4-1
4.2 Wood Surfaces (model 3500 only) ...................................................................... 4-2
4.3 Reusable Skin Temperature Probe ..................................................................... 4-2
4.1 Cleaning
WARNING:
w
Disconnect power to the Warmer and allow the heat rod to cool before
cleaning to avoid the possibility of a burn.
Clean the Warmer at least once a week or after each patient. Cleaning procedures for
the Warmer and accessories are explained in the following sections.
CAUTION:
w
Use the cleaning solution sparingly on a cloth when cleaning the warmer. Do
not saturate the unit - excessive solution causes damage to internal compo-
nents.
1. Unplug the power cord.
2. Clean the exterior of the warmer using mild detergent solution applied with a damp
cloth or sponge. Aqueous solutions which are U.S. Environmental Protection
Agency approved hospital level disinfectants may be used.
Do not allow liquids to seep into the electrical housing.
CI.10.013
Front/Rear
Panel
Push end pins
in for
installation
and removal.
Foam Mattress
Side Panel
Figure 4-1
Disassembly for cleaning