Ohmeda Ohio 2000 IWS Series, Руководство по эксплуатации и обслуживанию

Страница: 37 / 80

3-13
6600-0255-000 12/20/00
3/Operation
3-13
3.6 Side Panel Operation
(See Figure 3-5.)
WARNING:
w
Do not leave the patient unattended when the side panels are lowered.
w
Do not move the warmer by pushing or pulling on the bedside panels.
This action may lead to the deterioration and breakage of the components
which form a safety barrier around the infant.
w
Ensure that the bedside panels are locked in position when a patient
occupies the bed. Blankets or other foreign objects may prevent the
latches from fully engaging.
To lower a side panel, pull it up and then pull the top edge away from the bed. On the
model 3500 bassinet, the side panel locking mechanism must first be unlocked.
To raise a side panel, swing it to the upright position; then allow it to engage in the
latched position.
To remove a side panel, lower the side panel, press the end pins in and lift the side
panel out.
To replace a side panel, hold the end pins in, place the side panel in position and
release the end pins.
CI.05.010
Push pins in to install
or remove side
panels.
The Tubing Organizer Rear Side Panel aids in routing tubing to patients receiving
therapy in warmer beds. The various size holes in the panel can accommodate large
diameter tubes, such as aerosol tubes or the fiber optic cable of a BiliBlanket™ Sys-
tem; or smaller diameter tubes, such as ventilator or I.V. tubes. See Figure 3-6.
WARNING:
w
Install tubing in the appropriately sized holes. Use of inappropriate holes
may cause kinking, pinching or restriction of flow through the tubes, and
may interfere with the proper operation of therapy equipment.
w
Do not install chest drainage tubes in the Tubing Organizer Rear Side Panel.
Figure 3-5
Side Panel operation