Ohmeda Ohio 2000 IWS Series, Руководство по эксплуатации и обслуживанию

Страница: 34 / 80

3-10
6600-0255-000 12/20/00
3/Operation
3-10
Connect the skin temperature probe to the Warmer by plugging the probe connector
into the left side of the display module as viewed from the front. (See Figure 3-3.)
CAUTION:
w
Always remove the probe from the patient by grasping and removing the heat
reflective patch first, then remove the probe from the patient or the patch. Always
remove the probe from the Warmer by grasping the plug at the panel. Placing
excessive strain on the skin temperature probe lead wire can damage the probe.
CI.05.011
CI.02.006
White Paper
Protector
Heat Reflecting Patch
with Foil Side Facing Up
Note: Avoid placing
excessive strain
on the skin temperature
probe lead. Always
remove the probe by
grasping the plug at the
panel. Do not pull on the
probe lead wire.
Figure 3-2
Skin Temperature Probe attachment
Patient Probe
(Place the metal side in contact with
the infant’s skin)
Figure 3-3
Temperature Probe connection to the Display Module
5. Servo Mode Operation. (all models except the 2001 International)
Note: The skin temperature probe must be properly attached before starting servo
mode operation. Refer to step 4.
You must select a servo control temperature setting when the Warmer is used in
the servo mode for the first time. You are prompted to make this setting with an
operator prompt tone and the flashing of the control temperature display.